15
ENTERING VALUES
For an infusion parameter to be entered and/or edited, the pump displays the name of
the value being edited (rate, doserate, etc), format and unit of measure (dosing unit,
volume, time, etc).
In the screen below, a Doserate value is to be entered, which in this case is specified as
mcg/kg/h. The underbars indicate the places which can be entered both to the left
and right side of the decimal point.
The value to be entered must be selected by using the arrow buttons to move the
cursor so the desired numerical value to be changed is highlighted. Use the Left and
Right arrows buttons to move the cursor and the Up and Down arrows keys to increase
or decrease the number.
Entering a new value:
Titrate an existing value:
Select the value to be changed by using the right r and left arrow l keys to high-
light desired number, in this case the “ones” place.
ENTERING VALUES
For example, a value of 9.5 can be entered
by pressing the Up arrow button uin the
“ones” place 9 times and then press the
Right arrow button r once to move the
cursor to the “tenths” decimal place and
pressing the Up arrow button u 5 times.
Press the OK button k to confirm the
value, as indicated in the title bar of the
display.
To Titrate to another value, e.g. 11.5 press
the Down arrow button d eight times to
get 1.5
Then press the Left arrow button l to
move the cursor to the “tens” place and
press the Up arrow button u once .
To Next Page
Loading...
