63
Caution: The pump must be switched off before opening the battery
compartment.
Open the cover of the battery compartment (see ch. 1.12), unlock the battery by
sliding the green hook and pull out the battery using the metal handle.
Replace the Battery Pack SP in the battery compartment, lock it with the green
hook and test the proper placement by pulling the metal handle. Close the
battery compartment
ag
ain.
Note: In case of ESD, Pump may need to be plugged into wall outlet to re-start
the battery.
The battery is charged by the pump during connection to A/C power. When
disconnected from A/C or in case of power failure, the pump automatically
switches to battery power.
Connection to A/C power is displayed by the symbol in the main menu of
the pump. Recharging of WiFi battery while connected to A/C po
we
r and active
WiFi is ensured as long as environmental temperature outside Infusion pump is
35 °C (95°F).
Attention: If the battery module is stored for long periods of time outside the pump, it
is recommended to fully charge the battery and store it at room temperature.
Caution: Batteries may explode or leak if they are opened or
incinerated. Consider disposal directions!
The status of the wireles
s connection is
displayed in the run screen. When the
wireless transmitter is switched off, no
symbol is shown in the status of the run screen.
If the wireless is activated, the status of the connection is shown.
Wireless operation mode is switched
on but no connection to the network.
Note: An “X” through the wireless antenna indicates wireless connection has been lost,
contact your bio-medical engin
eering or IT department to determine cause.
Wireless operation mode is switched on
on and connection to the network is
established.
Further status information regarding the
status of the wireless connection can be
viewed in the Status menu.
BATTERY OPERATION AND MAINTENANCE
Chapter 6
To Next Page
Loading...
