Braun Infusomat Space - Page 72

72
Guidance and manufacturer’s declarartion on electromagnetic compatibility
Emissions test
Guidance and manufacturer’s declaration – electromagnetic emission
The Space System is intended for use in the electromagnetic environment specified below. The
customer or the user of the Space System or any component should assure that it is used in such
an environment.
RF emissions
CISPR 11
Compliance
Group 1
Electromagnetic environment guidance
The Space System uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment.
If WLAN-Module is installed within Battery module
(8713182U) or WLAN USB Stick for SpaceCom
(8713185) is used RF energy is transmitted by the
Space System.
Refer to technical data of Battery-Pack SP with Wifi
IUF and/or SpaceStatio
n and SpaceCom for details.
RF emissions
CISPR 11
Harmonic
emissions
IEC 61000-3-2
Class B
(Note 2)
applicable only for
SpaceStation
Class A
Voltage fluctuations /
flicker emissions
IEC 61000-3-3
Note 1: Maximum emissions are measured with a complete system (SpaceStation and components).
Note 2: If Class A equipment is attached to the Space System, the Space System will become Class
A too. This equipment/system may cause radio interference or may disrupt the operation of nearby
equipment. It may be necessary to take mitigation measures, such as re-orienting or relocating the
Space System or shie
lding the location.
Complies
The Space System or any component is suitable for
use in all establishments, including domestic
establishments and those directly connected to the
public low-voltage power supply network that
supplies buildings used for domestic
purposes.
Chapter 8
TECHNICAL DATA