2. FUNCTION SETTINGS
9
BAS-342G
Feed settings
No.
Setting
value
Setting item
Default
value
Mechanism home position return when sewing is finished
OFF The feed plate returns to the sewing start position at the sewing end.
250
ON
When sewing is finished, the feed plate moves via the machine home position to
the sewing start position.
OFF
Feed speed
1 100 mm/s Slow
2 200 mm/s
3 300 mm/s
4 400 mm/s
251
5 500 mm/s Fast
3
High-speed test feeding
OFF Normally slow, but becomes faster when the work clamp switch is depressed.
252
ON
Test feeding is at the same speed as sewing.
* This does not apply to checking stitch by stitch.
OFF
Home position detection method
OFF Depress the start switch while the program number is flashing.
253
ON
Press the special external input switch [EXIN3] while the program number is
flashing. (Start switch is disabled.)
OFF
Movement route to home position and sewing start position (*7)
0 No route specified
1
Moves in the order XY when moving to the home position, and in the order Y X
when moving to the sewing start position
2
Moves in the order YX when moving to the home position, and in the order X Y
when moving to the sewing start position
254
3 Moves while avoiding the middle of the work clamp
0
Changes the overall feed timing
260
-10 -
10 -10: Early 0: Standard 10: Late
0
Changes the feed timing for the 1st stitch at the sewing start
261
-10 - 10
-10: Early 0: Standard 10: Late
0
Changes the feed timing for the 2nd stitch at the sewing start
262
-10
- 10
-10: Early 0: Standard 10: Late
0
Changes the feed timing for the 3rd stitch at the sewing start
263
-10 - 10
-10: Early 0: Standard 10: Late
0
Changes the feed timing for the 3rd stitch before the sewing end
264
-10
- 10
-10: Early 0: Standard 10: Late
0
Changes the feed timing for the 2nd stitch before the sewing end
265
-10
- 10
-10: Early 0: Standard 10: Late
0
Changes the feed timing for the 1st stitch before the sewing end
266
-10
- 10
-10: Early 0: Standard 10: Late
0
If the overall feed timing (setting for No. 260) is changed from the default value, this specifies the
number of applicable stitches.
0 No limit
267
1 - 99
The feed timing returns to the standard feed timing once the specified number of
stitches has been sewn.
0
Changes feed timing reference
0 [Feed start reference] Makes the timing uniform at the start of feed.
1
[Need up reference] Changes the timing at the start of feed so that the needle
zigzagging is even.
2 [Feed end reference] Makes the timing uniform at the end of feed.
268
3 This cannot be set for the BAS-342G.
1
Home position detection operation when the program is changed
0 Disabled
1
Home position detection operation is disabled, but feed moves through the middle
of the sewing area.
270
2 Enabled
0
*7 Also change the settings for memory switch No. 250 and No. 270 as necessary.
To Next Page
Loading...
Need help?
General
