Brother BAS-342G - 12. TABLE OF ERROR CODES; Switch-related errors; Upper shaft motor-related errors

6. ASSEMBLY
BAS-342G
66
(Continued on the next page.)
17. Belt holde
r
18. Bolts [4 pcs]
(Temporarily tighten)
19. X base plate
20. Bolts [16 pcs]
Set the X linear guide (b) against
the X base plate (19) as shown in
the illustration, and then tighten
the bolts (20).
Install the belt holde
r
(17) so that the side
w
ith the countersunk
hole is at the top.
1291B
1292B
21. Y base plate tool
22. Bolts [2 pcs]
23. Bolts [16 pcs]
Install the Y base plate
tool (21) so that its edges
are positioned as shown
in the illustration.
* Once installation is complete, remove the Y base plate tool (21).
Edge
Edge
Edge
Countersunk
hole
1355B