6-124
Disassembly / Replacement / Adjustment
(4) Warp the ink level detection plate 2 inward to unlock the latch.
(5) Rotate the body 90 degrees with the boss as a fulcrum, take out the ink level detection plate 2 while removing the
boss.
(6) Insert cardboards or other thin plates into the left and right gear pressure plates. Warp the rear end of the lid to
detach the ribs so that they can get over the stepped portions of the stopper. Then remove the lid by sliding it in the
direction reverse to the normal direction.
<IMPORTANT>
ï‚· Avoid applying an excessive force when warping the lid. Otherwise, it could be damaged.
Ink level
detection plate 2
Boss
Latch
Latch
Ink level detection plate 2
To Next Page
Loading...
