Brother GTX-4 - Page 450

8-33
Error code list
Error Error message Description Remedy
6102 [Machine Error]
The carriage has stopped
abnormally.
Clean the ink mist adhered inside the printer
(carriage roller, roller guide, and carriage guide
shaft).
Clean the carriage belt and pulley.
Clean the encoder strip.
Adjust the CR speed on the menu again.
Check the connectors of the head and carriage
circuit board.
Replace the carriage motor.
Replace the encoder strip.
Replace the encoder circuit board.
Replace the carriage circuit board.
Replace the main circuit board.
6103 [Machine Error]
The carriage has failed in cap
locking.
Items to be checked:
Turn off the power and move the carriage by hand
to check to see if the locker is hooked.
Reactivate the power supply and check to see if
any error occurs again.
Clean the carriage encoder and carriage roller.
Check to see if any ink, cleaning solution, etc.
adhere to the maintenance circuit board.
Check to see if the carriage locker rotates the
maintenance cam to move up and down.
6104 [Machine Error]
The carriage does not work at
all.
Clean the ink mist adhered inside the printer
(carriage roller, roller guide, and carriage guide
shaft).
Clean the carriage belt and pulley.
Clean the encoder strip.
Adjust the CR speed on the menu again.
Check the connectors of the head and carriage
circuit board.
Replace the carriage motor.
Replace the encoder strip.
Replace the encoder circuit board.
Replace the carriage circuit board.
Replace the main circuit board.