5-14
Confidential
1.3.7 Change OnePushDemo function setting (function code: 28)
<Function>
This function is used to implement Demo printing by pressing the [Go] key, and is mainly
used for sales promotion at dealers. This function is disabled once printing is performed from
the computer. Change the setting to enable the function.
OnePushDemo = ON(Enabled) / OFF(Disabled).
The setting currently selected is marked "*".
<Operating Procedure>
(1) Press the [▲] or [▼] key in the initial state of maintenance mode to display
"MAINTENANCE 28" on the LCD, and press the [OK] key. "OnePushDemo=ON" is
displayed on the LCD.
(2) Press the [▲] or [▼] key to display "OnePushDemo=ON" when enabling this function or
"OnePushDemo=OFF" when disabling this function.
(3) Press the [OK] key. The setting currently displayed is saved, and the machine returns to
the initial state of maintenance mode.
Note:
• To cancel operation and return to the initial state of maintenance mode, press and hold
the [Go] key.
• Once the OnePushDemo function is enabled, this will not be disabled even when
printing is performed from the computer as long as the power switch is not turned OFF.
However, if the power switch is turned OFF and then ON again after the OnePushDemo
function was enabled, this function will be disabled when printing is performed from the
computer.
To Next Page
Loading...
Need help?
General
