5-44
Confidential
2.2 Change USB No. Return Value / Adjust Left-end Print
Start Position on Second Side when Duplex Printing
(LCD models only)
(The same function as that described in “1.3.10 Change USB No. return value / Adjust left-end
print start position on second side when duplex printing (function code: 45)” for LCD models)
Change USB No. return value
When the operating system (OS) installed on the computer is Windows Vista
®
, and the
machine is connected to this computer using USB2.0FULL, the OS may not be able to obtain
the USB device serial number depending on the computer and USB device. If the serial
number cannot be obtained, the number of devices increases each time the device is
connected to the computer. To avoid this problem, fix the USB No. return value to "0".
The setting currently selected is marked "*" at the end of the display.
<Operating Procedure>
(1) Press the [Go] and [▼] keys simultaneously while the machine is in the ready state.
Check that "USBNo." is displayed on the LCD and release the keys.
(2) Press the [OK] key. "USBNo.=ON" is displayed on the LCD.
(3) Press the [▲] or [▼] key to select "USBNo.=ON" or "USBNo.=OFF", and then press the
[OK] key. "Accepted" is displayed on the LCD, and the machine returns to the initial state
of maintenance mode.
(4) Turn the power switch OFF.
Adjust left-end print start position on second side when duplex printing
<Function>
In the event that the left-end print start position deviates on the second side when duplex
printing, use this function to adjust the position left and right. The adjustable range is -100 to
750 (unit: 300 dpi). (Shifted to left when the value is negative)
<Operating Procedure>
(1) Press the [Go] and [▼] keys simultaneously while the machine is in the ready state.
Check that "USBNo." is displayed on the LCD and release the keys.
(2) Press the [▲] or [▼] key to display "DX.XAdjust" on the LCD, and press the [OK] key.
"DX.XAdjust=**" is displayed on the LCD.
(3) To shift the writing start position to the left, press the [▼] key to decrease the value. To
shift the position to the right, press the [▲] key to increase the value.
(4) Press the [OK] key after adjusting the value. "Accepted" is displayed on the LCD, and
the machine returns to the initial state of maintenance mode.
LCD Description
USBNo. = ON Returns "0".
USBNo. = OFF Returns the serial number of the machine. (Default)
Note:
• This setting is applied after the power switch is turned OFF and then ON again.
To Next Page
Loading...
Need help?
General
