5-26
Confidential
1.3.15 Setting by spec (function code: 74)
<Function>
This function is used to customize the machine according to language, function settings, and
worker switch settings.
<Operating Procedure>
(1) Press the [▲] or [▼] key in the initial state of maintenance mode to display
"MAINTENANCE 74" on the LCD, and press the [OK] key. The country code currently
set is displayed on the LCD (The first digit is flashing).
(2) Press the [▲] key to enter "1", or the [▼] key to enter "0". Then press the [OK] key. The
second digit starts to flash.
(3) Press the [▲] key to enter "1", or the [▼] key to enter "0" similarly. Then press the [OK]
key. The second digit is completed and the fourth digit starts to flash.
(4) The third digit and fourth digit changes at once when the [▲] or [▼] key is pressed.
Press the [Go] key when the desired value is shown on the LCD. The new setting is
saved, and "PARAMETER INIT" is displayed on the LCD. The machine then returns to
the initial state of maintenance mode.
Note:
• If there is no entry for one minute or longer, the machine returns to the initial state of
maintenance mode automatically, regardless of the display status.
To Next Page
Loading...
Need help?
General
