Confidential
3-77
(5) Remove the Panel insulation sheet L and R.
(6) Release the three Hooks to remove the Panel PCB ASSY from the Panel unit.
(7) Release the Locks for the Connector (CN1) provided on the Panel PCB ASSY and
disconnect the FC harness.
Note:
- After disconnecting the flat cable(s), check that each cable is not damaged at its end or
short-circuited.
- When connecting the flat cable(s), do not insert it at an angle. After insertion, check that
the cable is not at an angle.
Fig. 3-85
(8) Remove the Rubber key (R, C, L) from the Panel unit.
Fig. 3-86
Panel PCB ASSY
Panel unit
Hooks
Lock
Lock
FC harness
Hook
Bosses
Bosses
Bosses
Bosses
Bosses
Panel unit
Rubber key R
Rubber key C
Rubber key L
CN1
Panel insulation sheet L
Panel insulation sheet R
To Next Page
Loading...
