5-41 Confidential
6) Fit the FFC support to the head joint, sliding it along the joint's cable clamp.
7) Route the head flat cable 1 as shown on page 5-35 and secure it to the lower cover with the
double-sided adhesive tape attached in 1) above.
8) Mount the head cover.
Flat core
Carriage PCB
Opening
Main PCB
Head flat cable 2 (19-pin)
Head flat cable 1 (17-pin)
FFC support
Lower cover
Double-sided
adhesive tape
Cable clamp on the
head joint
To Next Page
Loading...
