Brother MFC640CW - 8.2 List of Maintenance-Mode Functions

8-2 Confidential
8.2 LIST OF MAINTENANCE-MODE FUNCTIONS
Maintenance-mode Functions
Function
Code
Function
Reference
Section (Page)
01 EEPROM Parameter Initialization 8.4.1 (8-5)
05 Printout of Scanning Compensation Data 8.4.2 (8-6)
09 Test Pattern 8.4.3 (8-8)
10 Firmware Switch Setting 8.4.4 (8-10)
11 Printout of Firmware Switch Data 8.4.4 (8-13)
12 Operational Check of LCD 8.4.5 (8-15)
13 Operational Check of Control Panel PCB
(Check of Keys)
8.4.6 (8-17)
32 Sensor Operational Check 8.4.7 (8-19)
53 Transfer of Received FAX Data and/or Equipment's Log 8.4.8 (8-21)
54 Fine Adjustment of Scanning Start/End Position 8.4.9 (8-23)
55 Acquisition of White Level Data and CIS Scanner Area Setting 8.4.10 (8-24)
58 Updating of Paper Feeding Correction Value 8.4.11 (8-25)
59 Specifying of CIS Type 8.4.12 (8-29)
63 Travel Check of Head/Carriage Unit and Initial Setup Mode 8.4.13 (8-31)
65 Alignment of Vertical Print Lines in Monochrome 8.4.14 (8-32)
66 Margin Adjustment in Near-edge Printing 8.4.15 (8-35)
68 Updating of Property Data 8.4.16 (8-38)
69 Head/Carriage Unit Traveling Speed Check 8.4.17 (8-40)
74 EEPROM Customizing 8.4.18 (8-41)
75 Travel of Head/Carriage Unit (for Recovery from Paper Jam
Caused at Maintenance Unit)
8.4.19 (8-42)
76 Purging Operation 8.4.20 (8-43)
80 Display of the Equipment's Log 8.4.21 (8-46)
82 Equipment Error Code Indication 8.4.22 (8-49)
87 Output of Transmission Log to the Telephone Line 8.4.23 (8-49)
91 EEPROM Parameter Initialization (except the telephone number
storage area)
8.4.1 (8-5)
99 Exit from the Maintenance Mode ----- (8-1)
Menu/Set (Menu)
+ #, 2, 7, 9, 0, 0
Cancellation of the Pin TX Lock Mode (Not applicable to
U.S.A. models)
8.4.24 (8-50)