Brother MFC640CW - Page 224

8-26 Confidential
(6) MFC820CW/640CW
Press the 5 and 8 keys on the machine.
DCP340CW
Enter 5 and 8 by using the
and Set keys on the machine.*
(*To enter a numerical code on models having no numerical keypad, press the key several times to
display the numerical code to be entered and then press the Set key. Repeat this operation for each
numerical code.)
The "1.PF 2.EXIT" appears on the LCD.
(7) MFC820CW/640CW
To select the paper feed roller adjustment, press the 1 key.
DCP340CW
To select the paper feed roller adjustment, enter 1 by using the
and Set keys.*
The "PF ADJ NO. +0" appears on the LCD.
(8) Check the PF adjust check patterns ("A" on page 8-28) and select the one that is the least
uneven print. Make a note of that pattern number.
If the unevenness is far to the left of check pattern -8, regard it as -8; if it is far to the right of
check pattern +8, regard it as +8. In this case, you need to check whether the paper feed roller
and head/carriage unit are set into place.
(9) Enter the number of the least uneven check pattern found in step (7).
MFC820CW/640CW
For example, if the number of the least uneven check pattern is +4, press the
and 4 keys; if -4,
press the
and 4 keys. (To enter +, use the key; to enter -, use the key.)
DCP340CW
For example, if the number of the least uneven check pattern is +4, enter + and 4; if -4, enter -
and 4 by using the
and Set keys.*
(*To enter a plus/minus symbol or numerical code on models having no numerical keypad, press the
key several times to display the / or numerical code to be entered, respectively, and then press the Set
key. Repeat this operation for each symbol or numerical code.)
The machine automatically returns to the initial stage of the maintenance mode.
(10) MFC820CW/640CW
Press the 5 and 8 keys on the machine.
DCP340CW
Enter 5 and 8 by using the
and Set keys on the machine.*
The "1.PF 2.EXIT" appears on the LCD.
(11) MFC820CW/640CW
To select the paper ejection roller adjustment, press the 2 key.
DCP340CW
To select the paper ejection roller adjustment, enter 2 by using the
and Set keys.*