Brother MFC640CW - Page 234

8-36 Confidential
(7) MFC820CW/640CW
If either margin is out of the specified range, press the 6 key twice on the machine.
DCP340CW
If either margin is out of the specified range, enter 6 twice by using the
and Set keys on the
machine.*
(*To enter a numerical code on models having no numerical keypad, press the key several times to
display the numerical code to be entered and then press the Set key. Repeat this operation for each
numerical code.)
The "MEDIA SENSOR ADJ" appears again.
(8) MFC820CW/640CW
To make the machine ready for data entry, press the * key.
DCP340CW
To make the machine ready for data entry, enter * by using the
and Set keys.*
(9) Enter the measured value (in units of 0.1 mm) multiplied by 10.
(Example) Left: 10, Right: 13
MFC820CW/640CW
In this example, press 1, 0, Menu/Set (Menu), 1, 3, and Menu/Set (OK) keys.
DCP340CW
In this example, enter 1, 0, 1, and 3 by using the
and Set keys.*
(*To enter a numerical code on models having no numerical keypad, press the key several times to
display the numerical code to be entered and then press the Set key. Repeat this operation for each
numerical code.)
(10) Upon completion of the entry, the machine automatically returns to the initial stage of the
maintenance mode.
Go back to step (5) and print out the margin check pattern again.
(11) Measure the left and right margins on the printout.
If both margins are within the range from 0.9 to 1.1 mm, the adjustment is completed.
TIP: To reset the newly entered values to defaults, press the Black Start or Mono Start key.