Brother P-Touch QL-1050 - Page 38

III- 13
(4) Disconnect the power supply harness from the power supply PCB.
Fig. 3.1-13 Removing the Power Supply PCB and Main PCB (3)
(5) Remove the three screws and remove the ground spring plate and FG harness ASSY
from the main PCB.
Fig. 3.1-14 Removing the Power Supply PCB and Main PCB (4)
Ground spring plate
Screw
Screw
Screw
Main PCB
Power supply PCB
Power supply harness
FG harness ASSY