III- 12
[ 4 ] Removing the Power Supply PCB and Main PCB
(1) Turn the machine upside down.
(2) Remove the three screws and remove the power supply PCB and DC8V power PCB
ASSY.
Note: The power supply PCB and DC8V power PCB cannot be removed from the
machine in this status since the inlet of the power supply PCB is still assembled
onto the under cover.
Fig. 3.1-11 Removing the Power Supply PCB and Main PCB (1)
(3) Remove the DC8V power PCB ASSY from the power supply PCB.
Note: The power supply PCB and DC8V power PCB are connected each other with the
pin. When disassembling the DC8V power PCB, be careful not to bend the pin.
Fig. 3.1-12 Removing the Power Supply PCB and Main PCB (2)
Power supply PCB
DC8V
power PCB ASSY
Screws
Screw
DC8V
power PCB ASSY
Power supply PCB
Pin
Inlet
To Next Page
Loading...
