Brother P-Touch QL-1050 - Creating Labels (For Windows)

iii
[ 3 ] Installing the Mecha ASSY and Cutter unit ASSY.......................................... III-34
[ 4 ] Installing the Front Side Cover, Panel Cover and Front Cover ...................... III-37
[ 5 ] Installing the Upper Cover ASSY.................................................................... III-40
[ 6 ] Installing the Power Supply and Main PCB.................................................... III-42
[ 7 ] Reassembling the Top Cover ASSY .............................................................. III-46
[ 8 ] Installing the Top Cover ASSY and Thermal Tape ........................................ III-48
[ 9 ] Demonstration Print and Final Check............................................................. III-50
CHAPTER IV TROUBLESHOOTING AND ERROR MESSAGE........................ IV-1
4.1 PRECAUTIONS ........................................................................................................ IV-1
4.2 AFTER REPAIRING.................................................................................................. IV-1
4.3 ERROR MESSAGE .................................................................................................. IV-2
4.4 TROUBLESHOOTING FLOWS................................................................................ IV-3
[ 1 ] Printing is performed with specific dots omitted ............................................. IV-3
[ 2 ] The tape is not detected correctly .................................................................. IV-4
[ 3 ] LED does not turn on...................................................................................... IV-5
[ 4 ] No printing is performed ................................................................................. IV-6
[ 5 ] The USB interface malfunction....................................................................... IV-7
[ 6 ] The RS232C interface malfunction................................................................. IV-8
[ 7 ] The tape is not cut .......................................................................................... IV-9
[ 8 ] The tape is not fed correctly ........................................................................... IV-10
[ 9 ] The tape is fed, but the error message appears shortly................................. IV-11
APPENDIX 1 MAINTENANCE SOFTWARE OPERATION................................ 1
APPENDIX 1.1 Purpose and Use Procedure of the Reset Software Tool
(QL1050tstReset.exe)............................................................................. 1
APPENDIX 1.2 Setting and Use Procedures of the Maintenance Software Tool
(QL1050tstSE.exe).................................................................................. 2
APPENDIX 1.3 Use Procedure of the VR Adjustment Tool
(QL1050tstVRAdjust.exe) ....................................................................... 23