Brother P-Touch QL-1050 - Page 61

III- 36
(5) Assemble the cutter unit ASSY with the two screws while paying attention to the harnesses
inside.
Fig. 3.2-17 Installing the Mecha ASSY and Cutter unit ASSY (5)
(6) Put each of the harnesses of the cutter unit ASSY through the holes on the under cover.
Fig. 3.2-18 Installing the Mecha ASSY and Cutter unit ASSY (6)
Mecha ASSY
Cutter unit ASSY
Screws
Under cover
Rib
Hook
Hole
Cutter unit harness
Pass the harness
under the release
lever L.
Under cover
Cutter unit ASSY
Rib
Pass the harness
under the release
lever R.
Cutter home position
sensor harness
Rib