T401S Indicator User Instructions 53
8.4 Checkweighing application supervisor menu
Reset
Check Under divisions Over divisions Reset
9. Press UNITS …
rESEt is displayed. Use this to reset the all the checkweigher variables
to the factory defaults.
10. Press SELECT …
no is displayed.
11. Press ZERO to abort the reset or press UNITS …
YES is displayed.
12. Press ZERO to reset the settings to factory defaults …
rESEt is displayed.
13. Press TARE …
chEcK is displayed.
14. Press UNITS …
bAttErY is displayed. The battery menu is identical in all the
applications. Refer to step 1 on page 43 for information on setting up the
battery.
15. This completes the Supervisor menu for the Checkweighing application.
Repeatedly press TARE until the indicator returns to normal weighing mode.
The current weight value is displayed.
To Next Page
Loading...