Dissassembly and Disposal
100 SnackFix 2016-08
11 Dissassembly and Disposal
11.1 Safety
Elekt_3_Anl
Electrocution danger!
Electrocution danger exists when live components are touched.
Electrical components which are switched on can carry out
uncontrolled movements and lead to serious injury or death.
Before beginning work, switch off the electrical power supply and
secure against restarting.
Mech_1_Bewegt
Danger of injury from moving components!
Rotating and/or components moving linearly can cause serious
injuries.
Do not touch or handle moving components during operation.
Do not open covers or housing during operation.
Observe the after-run time: Before opening the covers or hous-
ing, make sure that no components are still moving.
Wear close-fitting protective clothing in the hazard zone with
low tear strength.
Temp_1_Oberfl
Danger of injury from hot surfaces!
Component surfaces can heat up greatly during operation. Skin
contact with hot surfaces causes serious burns.
Always wear heat-resistant protective clothing/gear and protec-
tive gloves when working near hot surfaces.
Before starting any work, make sure that all surfaces have
cooled down to the ambient temperature.
To Next Page
Loading...
