Figure 6. Align the Butterfly iQ+ cable prior to installation
Figure 7. Expected gap between the cable strain relief and probe body after installing
the Butterfly iQ+ cable
Replacing the Butterfly iQ3 Cable
1. Remove the existing cable from the Butterfly iQ3 probe. Wrap the probe cable around your wrist while holding
the probe firmly in the other hand. Push the cable release button and pull the two apart. Do not use tools to
grab the strain relief or the cord, as doing so might damage the cable.
Figure 8. Removing the Butterfly iQ3 cable
2. Align the connector and the probe, and push the cable firmly into the probe body. When the cable is fully
installed, you will feel a light “click” when the cable lock feature on the probe engages with the cable.
Replacing the Butterfly iQ+/ iQ3 Cable
Maintenance 84
To Next Page
