BWT AQA perla XL - How Safety Instructions Are Displayed; Symbols Used; Transport and Installation

51
51
EN
1.4 Transport and installation
To avoid damage during transport to the installation
location, do not remove the BWT product from the
packaging until you have reached the relevant lo-
cation. Then dispose of the packaging in the correct
manner. Check that the delivery is complete.
If there is a risk of frost, drain all components that
convey water.
Lift or transport the product or its components only
from the designated suspension eyes or attachment
points, if present.
Theproductmustbeinstalledormountedonasuf-
cientlystrongandlevelhorizontalsurfaceandmust
be adequately secured against falling or tipping.
1.5 Symbols used
This symbol indicates general
risks due to the mains voltage.
Risk of death by electric shock!
This symbol indicates that this
electrical and electronic equip-
ment must not be disposed of
with household waste at the end
of its life.
This symbol indicates that the
product can be recycled at the
end of its life.
This symbol indicates informati-
on or instructions that you must
observe in order to ensure safe
operation.
1.6 How safety instructions are
displayed
In this document safety instructions precede any
sequence of actions that could cause harm to per-
sonsordamagetoproperty.Allhazardprevention
measures must be followed.
Safety instructions are displayed as follows:
SIGNAL WORD!
Source of hazard
(e.g. electric shock)
Type of hazard (e.g. risk of fatal
injury)!
► Escape or prevent hazard
► Rescue measure (optional)
Signal word / colour Indicates the severity
ofthehazard
Warning symbol Calls attention to the
hazard
Source / type of
hazard
Indicates the type
and the source of the
hazard
Consequences of
hazard
Explains the conse-
quences of not fol-
lowing the safety in-
structions
Hazard prevention
measure
Explains how to avoid
thehazard