BWT AQA perla XL - Connections

60
EN
12
13
Routetheushingwaterhose(12)ataninclineto
thesewagesystemconnection(drain)andsecure
theendwiththexingmaterialsuppliedtoprevent
itappingaboutwhenunderpressure.
Attachtheoverowhose(18x24)totheoverow
(13).Secureitwithcabletiesandrouteitwithan
incline of at least 10 cm to the sewage system
connection(drain).
The two hoses connected to the sewage system
may not be connected or constricted at any point.
InaccordancewithEN1717,theushingwaterand
overowhosesmustbeconnectedtothesewage
system at least 20 mm above the highest possible
wastewaterlevel(unimpededdrainage).
Placetheoorsensorontheoor.
6.2 Connections
Only the following connections are required on the
underside of the electronics housing:
Cover (2), remove the 2 large plastic screws,
lift up the flap with the electronics and hold it
securely.
● Central instrumentation and control (CIC) sys-
tem,CIC connection (red RCA socket) for low
salt, etc.
● Control connection for metering pumps (white
RCAsocket)
● USB socket
● Socket for blending equipment
> 20 mm