BWT AQA perla XL - Page 77

77
77
EN
Regeneration time
Audible alarm No
High-ow No
AQA Stop Yes
Sensor No
Rinse / Hygiene No
AQA Watch Yes
Filter No
Screensaver Yes
AQA Stop trigger volume 9999 l
Unit set-up - customer
High-owoperation
Function cannot be set
AQA Stop
Floor sensor for detecting moisture in conjunction
with water volume monitoring.
AQA Stop trigger volume
Congurablewatervolumewhich,oncereached,
will trigger the water supply to be shut off.
Sensor
Function cannot be set
Rinse / Hygiene
R: The rinse function is an additional soft
water rinse, which is recommended for
operation with dwownstream reverse
osmosis, steam generator etc.
H:  Asanitizingushingofbothexchanger
columnsafter24hwithnowaterow
R+H: Both functions active
AQA Watch
The AQA Watch function monitors the building’s
water supply system for consistently low
(< 60l /h) ow rates (consistently low ow rates
indicateaprobleminthepipelinenetwork).
The control unit issues a warning if an error occurs.
The CIC contact opens in the event of an error or a
power failure. (Max. contact assignment: DC 24 V,
0.5A.)
Filter
Aremindertochangeorbackushthelterelement
every6months,ltertypeBackwash,E1orChange
can be selected
Screensaver
Appears after 15 minutes of inactivity
Switch on/off