1502154 Rev D Reference Tables D-1
APPENDIX D
Reference Tables
This section presents product tables that support the balancing procedures of Factory-Shipped
Configurations for Flex Max901e Trunk and Bridger Amplifiers on page 5-9 and Return Balancing on
page 5-20.
Use Of Accessory Tables—page D-1
Installing Plug-in Accessories—page D-4
Accessory Tables—page D-6
Use Of Accessory Tables
There are two methods for using the Accessory Tables to determine the correct accessory needed to
balance an Flex Max901e:
■ When the Equalization Value is Known
■ When Preceding Cable Loss and Internal Equalization are Known
When the Equalization Value is Known
This procedure assumes prior calculation of the Equalization Value as defined in the Forward
Balancing procedure (Refer to Factory-Shipped Configurations for Flex Max901e Trunk and Bridger
Amplifiers on page 5-9.)
■ If the Equalization Value calculated during Forward Balancing is positive, you will need to
use an equalizer to balance the Flex Max901e and should refer to Equalizer Selection
(Positive Equalization Value).
■ If the Equalization Value calculated during Forward Balancing is negative, you will need to
use a cable simulator to balance the Flex Max901e and should refer to Cable Simulator
Selection (Negative Equalization Value) on page D-2.
To Next Page
Loading...