1
1-6 Flex Max901e 1GHz Trunk and Bridger Amplifiers 1502154 Rev D
Part Number Example
Based on the Flex Max901e bridger amplifier model options, a Flex Max901e with the part number,
FMBEGPJ-KB7P6F4N, has the following options:
■ Flex Max901e series bridger amplifier—FMBE
■ 1002MHz—G
■ 43dB spacing—P
■ 42/54MHz split—J
■ 439.25MHz TV ALC pilot frequency—KB
■ 18dB active gain with return switches—7
■ Two bridger outputs, user-configurable to four outputs with –20dB external forward
testpoints and internal return testpoints—N
■ 2.3A, 90V, 50/60Hz H.E. transformerless power supply—6
■ 6-port, Flex Max 1002MHz housing with external testpoints—F
■ Corrosion protected housing finish—4
■ EMS capable—N
Contact your C-COR sales professional for further information regarding the Flex Max901e and
Value Max transponders.
Document Conventions
This manual uses a different typeface to show text that is printed or silkscreened on Flex Max901e
modules. For example, ALC is silkscreened on the RF module faceplate to indicate the Automatic
Level Control switch setting.
This manual uses the following notes, cautions, and warnings:
WARNING Personal injury could result if instructions are not followed.
CAUTION Equipment damage may result if instructions are not followed.
Note Read for added information and reminders. A note can tell you when a service
interruption could occur.
Tip Read for helpful hints.
To Next Page
Loading...