C-COR Flex Max901e - Physical Identification of Flex Max901 e

1502154 Rev D Physical Identification 2-1
CHAPTER 2
Physical Identification
This chapter identifies and describes user-accessible testpoints, controls, plug-in locations,
connections, modules, and components for the Flex Max901e amplifiers. For specific testpoints,
controls, and connections for the power supply and AC distribution board, refer to Power Supply
Configuration on page 5-3. For information on the element management transponder, refer to
Housing Replacement on page 7-13.
Figure 2.1, Flex Max901e Trunk and Bridger Amplifier—page 2-2
Figure 2.2, Transponder Identification—page 2-5
Figure 2.3, Plug-in Accessory Insertion Guides—page 2-6