4
4-6 Flex Max901e 1GHz Trunk and Bridger Amplifiers 1502154 Rev D
Housing Mounting
Depending on the requirements of the system, Flex Max901es can be mounted in any one of the
following ways:
■ strand/pedestal mount
■ strand/pedestal mount with extension mounting brackets
■ wall mount
■ wall mount with EMBs
Strand/Pedestal Mounting
Both strand and pedestal mounting invoIve the use of a strand for mounting. In either case, strand
diameter determines the orientation of the strand clamp. Refer to Figure 4.4.
➤ To strand/pedestal mount
1. Attach the strand clamp assemblies to the top strand clamp bosses (mounting surfaces)
with the 1-inch (2.54cm) long clamp bolts and lock washers, threading the bolts 4 or 5
turns.
2. Hoist the housing to the strand and hang it in position.
3. Tighten the clamp bolts so that the housing cannot come off the strand, but can still be
adjusted.
4. Position the housing at a location on the strand that is accessible for attaching cables and
performing maintenance and balancing, and that complies with the requirements of the
system.
5. Torque the clamp bolts to between 40 and 66 in-lbs (4.5 and 7.5N·m).
To Next Page
Loading...