1
1502154 Rev D Introduction 1-9
Materials
1/4-20 UNC bolts and flat
washers
— Wall mounting
Heat gun or approved
torch and heatshrink
tubing, or weathersealing
tape or compound
— Weatherproofing RF cable and fiber optic
stub cable connectors
Anti-seize compound — RF cable attachment
Value Max Transponder
Mounting Kit
(P/N 1501024)
Transponder grounding bracket
(P/N 1500614), two bracket screws
(P/N 30039-0102), module cover
screw (P/N HS0160)
Secure Value Max transponder
1. An 11mm nutdriver or wrench can normally be used in place of a 7/16-inch tool if the bolt and nutdriver are
manufactured to nominal “across the flat” tolerances. A non-fit will occur if the nutdriver is manufactured to
minimum and the bolt head to maximum dimensions.
2. Small hold-down screws may be Phillips head screws or Torx PLUS head screws. Use the appropriate driver.
Table 1.1 Tools and Materials (cont’d)
Tools/Equipment Required Characteristics Uses
To Next Page
Loading...