cab - Produkttechnik GmbH30
Fig. 5c Switch on the printer
After making all connections switch on the printer at the power switch (1/2).
The printer carries out a short system test and following the display is shown
the system mode "ONLINE".
If a hardware failure occurs during the system test the type of the failure will be
shown. In this case the printer should be switched off and on again. If the
failure occurs again call the service.
If the display is not showing anything after switching on the printer, please
check the following whether:
- the connection of the power switch is correct
- the setting of the voltage selector corresponds with the power supply voltage
- the fuses in the voltage selector are not defective
If all these conditions are true and the device nevertheless cannot be switched
on call for service, please.
CAUTION !
If the fuses in the voltage selector are defective do not use the fuses of
the delivery contents as spare parts.
These fuses are only for using at the other operation voltage.
By using the fuses of the delivered contents without changing the setting
of the voltage selector, the printer may be damaged.
1 - Power switch Hermes 4N/4F
2 - Power switch Hermes 5N/5F
2
1
Switch on the printer
To Next Page
Loading...
Need help?
General
