cab - Produkttechnik GmbH32
Loading Labels
1. Place the label roll (1) onto the prepared media hub (3) and slide it against
the wind plate (5). The solid line represents the feed path of outside-rolled
labels, the broken line of inside-rolled labels.
2. Put the flange (4) on the supply hub (3), slide it against the label roll (1) and
fix it at the supply hub by tightening the knurled knob (2).
3. Swing the three levers (9, 19 und 16) clockwise until they stop and open
this way the transport system (10,11) and the backfeed system (17,18).
The printhead (15) also will be unlocked from the print roller.
4. Loosen the knurled knob (12) and slide the media guide (13) into its
outermost position.
Fig. 6b Media loading Hermes 4N/5N
10
1 2 3 4 5
678911121314
15
16
17
18
19
To Next Page
Loading...
