76 APOLLO Digital Broadcast Production Console Setup and Configuration
The control surface display brightness
can be adjusted and the surface
enters a screen saver / 'Dark Mode'
after a period of inactivity.
During dark mode, the displays are
switched off, but all control and audio
processing continues. The displays
will instantly switch on if any control is
changed. Touching a fader knob (without
even moving the fader) will activate its
touch sensor and bring the surface out
of dark mode straight away, without
changing control parameters. A 'Dark'
button/LED on the monitor panel flashes
to indicate when the console is in this
mode.
Pressing the Dark button on the monitor
panel will also put the console into this
mode, without waiting for the timeout.
The above settings can be accessed
from the Main Application, >System
Settings>Surface Illum page. Note that
the maximum dark mode timeout is 1 hour
and cannot be disabled.
SCREENSAVER TIMEOUT - 'DARK MODE'
To Next Page
Loading...
