Cambium Networks ePMP 1000 User Manual

CAMBIUM NETWORKS
026v003
118
12
Configure the parameter IP address:
Internet Protocol (IP) address. This address is used by the family of Internet protocols to
uniquely identify this unit on a network. To configure a simple test network, this field may be
left at default (192.168.0.1).
13
Configure the parameter Subnet Mask:
The Subnet Mask defines the address range of the connected IP network. To configure a
simple test network, this field may be left at default (255.255.255.0).
14
Configure the parameter Gateway:
The IP address of the device on the current network that acts as a gateway. A gateway acts
as an entrance and exit to packets from and to other networks. To configure a simple test
network, this parameter may be left at default (blank).
15
Configure the parameter IPv6 Assignment
IPv6 Assignment specifies how the IPv6 address is obtained.
Static: Device management IP addressing is configured manually in fields IPv6 Address and
IPv6 Gateway.
DHCPv6: Device management IP addressing (IP address and gateway) is assigned via a
network DHCP server, and parameters IPv6 Address and IPv6 Gateway are unused. If the
DHCPv6 server is not available previous static IPv6 address will be used as a fallback IPv6
address. If no previous static IPv6 address is available, no IPv6 address will be assigned.
DHCPv6 will occur over the wireless interface by default.
16
Configure the parameter IPv6 Address
Internet protocol version 6 (IPv6) address. This address is used by the family of Internet
protocols to uniquely identify this unit on a network.
IPv6 addresses are represented by eight groups of four hexadecimal digits separated by
colons.
17
Configure the parameter IPv6 Gateway
Configure the IPv6 address of the device on the current network that acts as a gateway. A
gateway acts as an entrance and exit to packets from and to other networks.
18
Configure the parameter WPA2 Pre-shared Key
Configure this key on the AP and then configure each of the network SMs with this key to
complete the authentication configuration. This key must be between 8 to 128 symbols. Click
the visibility icon to toggle the display of the key’s contents.
19
Click the Save icon, then click the Reset icon

Cambium Networks ePMP 1000 Specifications

General

Brand	Cambium Networks
Model	ePMP 1000
Category	Wireless Access Point
Language	English