SM Ping page
Use the SM Ping page to conduct a simple test of SM IP connectivity to other devices which are
reachable from the network. If no ping response is received or if “Destination Host Unreachable” is
reported, the target may be down, there may be no route back to the SM, or there may be a failure
in the network hardware (i.e. DNS server failure).
Figure 81 SM Ping page
Table 120 SM Ping attributes
IPv4: The ping test is conducted via IPv4 protocol.
IPv6: The ping test is conducted via IPv6 protocol.
Enter the IP address of the ping target.
Enter the total number of ping requests to send to the target.
Enter the number of data bytes to be sent.
Set the IP Time-To-Live (TTL) for multicast packets. This flag applies
if the ping target is a multicast address.
Displays the ping test results.
To Next Page
Loading...
Need help?
General
