TYPICAL DEPLOYMENT EQUIPMENT
The ePMP is a solution consisting of integrated or connectorized outdoor units, indoor power
supply units/LAN injectors, cabling and surge suppression equipment.
The main hardware components of an ePMP deployment are as follows:
ePMP 2000 Access Point with Intelligent Filtering and Sync or Connectorized Radio with GPS
Sync (ePMP 1000): A connectorized outdoor transceiver unit containing all the radio,
networking, and surge suppression electronics.
ePMP 2000 Access Point with Intelligent Sync Power Supply or GPS Sync Connectorized Radio
(ePMP 1000) Power Supply: An indoor power supply module providing Power-over-Ethernet
(PoE) supply and 1000/100/10 Base-TX to the Access Point.
ePMP 2000 Access Point with Intelligent Sync or GPS Sync Connectorized Radio (ePMP 1000)
Radio Cabling and lightning protection: Shielded Cat5e cables, grounding cables, and
connectors.
Integrated Radio: An integrated-antenna outdoor transceiver unit containing all the radio,
networking, antenna, and surge suppression electronics.
Integrated or Un-sync Connectorized Radio: A connectorized outdoor transceiver unit
containing all the radio, networking and surge suppression electronics.
Integrated Radio Power Supply: An indoor power supply module providing Power-over-
Ethernet (PoE) supply and 100/10 Base-TX to the Subscriber Module.
Integrated Radio Cabling and lightning protection: Shielded Cat5e cables and connectors
For more information about these components, including interfaces, specifications and Cambium
part numbers, see System hardware on page 32.