Cambium Networks ePMP 1000 User Manual

CAMBIUM NETWORKS
026v003
120
4
Configure the parameter Subscriber Module Mode:
This parameter controls the mode of operation of the Subscriber Module – An SM may be
configured to operate in TDD mode for point-to-point and point-to-multipoint access,
Standard WiFi mode providing the capability to connect to any AP operating in standard WiFi
mode or as an ePTP Slave. For initial link bring-up, choose TDD. When the SM is an ePTP
Slave, the system does not support GPS Synchronization but is able to provide significantly
lower latency than other modes. QoS (MIR and traffic priority) capability and Link
Quality/Capacity indicators are not available in this mode.
5
The Country is automatically retrieved from the AP and requires no configuration.
Country settings affect the radios in the following ways:
• Maximum transmit power limiting (based on radio transmitter power plus configured
antenna gain)
• DFS operation is enabled based on the configured country code, if applicable
• Frequency range of operation depending on local limitations
6
Configure the parameter Device Name:
The SM Device Name is used to identify the device on the network. This parameter may be
modified or left at the default value of Cambium-SM.
7
Configure the parameter Network Mode:
Bridge: The SM acts as a switch, and packets are forwarded or filtered based on their MAC
destination address.
NAT: The SM acts as a router, and packets are forwarded or filtered based on their IP header
(source or destination) which can be grouped into subnets for finer granularity.
Router: The SM acts as a router and packets are forwarded or filtered based on their IP
header (source or destination) using specific static routes and IP aliases configured by the
operator.
8
Configure the parameter Wireless IP Assignment:
If DHCP is selected, the DHCP server automatically assigns the IP configuration (Ethernet
(LAN) IP Address, Ethernet (LAN) IP Subnet Mask, Gateway IP Address (LAN)) and the values
of those individual parameters (below) are not used. To configure a simple test network, this
parameter must be configured to Static.
9
Configure the parameter Wireless IP Address:
Internet Protocol (IP) address. This address is used by the family of Internet protocols to
uniquely identify this unit on a network. To configure a simple test network, this field must
be configured to 192.168.0.2.
10
Configure the parameter Wireless Subnet Mask:
The Subnet Mask defines the address range of the connected IP network. To configure a
simple test network, this field may be left at default (255.255.255.0).
11
Configure the parameter Wireless Gateway:
The IP address of the device on the current network that acts as a gateway. A gateway acts
as an entrance and exit to packets from and to other networks. To configure a simple test
network, this parameter may be left at default (blank).

Cambium Networks ePMP 1000 Specifications

General

Brand	Cambium Networks
Model	ePMP 1000
Category	Wireless Access Point
Language	English