CHAPTER 4: USING THE DEVICE
MANAGEMENT INTERFACE
PAGE 4-53
Figure 20 Configuration > Security page (Subscriber Module Mode)
Table 43 Configuration > Security page attributes
Wireless Security
(Access Point Mode)
For Access Point mode devices, select the security mode enforced upon
network entry.
For Subscriber Module mode devices, select the security mode utilized upon
network entry attempts.
Open: All Subscriber Module devices requesting network entry are allowed
registration.
WPA2: The WPA2 mechanism provides AES radio link encryption and
Subscriber Module network entry authentication. When enabled, the
Subscriber Module must register using the Authentication Pre-shared Key
configured on the Access Point and Subscriber Module.
RADIUS: Enables Subscriber Module authentication via a pre-configured
Radius server.
Configure this key on the Access Point, then configure the Subscriber Module
with this key to complete the authentication configuration. This key must be
between 8 to 128 symbols.
RADIUS (Access Point Mode)
Servers
(Access Point Mode)
For more Radio servers, click Add. Up to 3 Radius servers can be configured
on the device with the following attributes:
IP Address: IP Address of the Radius server on the network.