CHAPTER 3: SYSTEM PLANNING
PAGE 3-29
Radio spectrum planning
This section describes how to plan ePMP links to conform to the regulatory restrictions that apply in the
country of operation.
Attention The user must ensure ePMP product operates in accordance to local
regulatory limits.
Note Contact the applicable radio regulator to check if registration of the ePMP link is
required.
General wireless specifications
The wireless specifications that apply to ePMP 802.11ac variants are listed under Table 35. The wireless
specifications that are specific to each frequency variant are listed in Table 36.
Table 35 Wireless specifications (all variants)
Manual selection (fixed frequency)
Automatic Channel Selection
To avoid interference to other users of the band, maximum power
can be set lower than the default power limit.
ePMP 3000 Access Point: 32 dBm
Force 300-25: 27 dBm
Force 300-16: 29 dBm
Integrated device antenna type
Force 300-25: Dish antenna
Force 300-16: Integrated patch
To Next Page
Loading...
Need help?
General
