CHAPTER 2: SYSTEM HARDWARE
PAGE 2-9
The ePMP 3000 connectorized module conforms to the specifications listed in Table 7 and Table 8.
The connectorized module meets the low level static discharge specifications identified in
Electromagnetic compatibility (EMC) compliance on page 6-71 and provides internal surge suppression
but does not provide lightning suppression.
Table 7 ePMP 3000 Access Point physical specifications
Dimensions (Length x Width x
Height)
22.2 cm x 12.4 cm x 4.5 cm (8.75 in x 4.9 in x 1.75 in) without
brackets
0.7 kg (1.5 lbs) without brackets
Table 8 ePMP 3000 Access Point environmental specifications
-30°C (-22°F) to +55°C (131°F)
124 mph (200 kph) maximum. See ePMP 3000 Access Point
wind loading (Kg) on page 2-10 for a full description.
ePMP 3000 Access Point heater
At startup, if the ePMP 3000 Access Point module temperature is at or below 32° F (0° C), an internal
only activated when the unit is powered on and will not apply heat to the device once startup is
complete. When the unit temperature is greater than 32° F (0° C), the heater is deactivated and the unit
continues its startup sequence.
The effect on device startup time at various temperatures is defined in Table 7.
Table 9 ePMP 3000 Access Point startup times based on ambient temperature
Startup time (from power on to operational)
ePMP 3000 Access Point wind loading
To Next Page
Loading...
Need help?
General
