CHAPTER 4: USING THE DEVICE
MANAGEMENT INTERFACE
USING THE INSTALLATION WIZARD ACCESS
POINT
PAGE 4-9
Defines the address range of the connected IP network. For example, if IP Address
is configured to 192.168.2.1 and Subnet Mask is configured to 255.255.255.0, the
device will belong to subnet 192.168.2.X.
Configure the IP address of the device on the current network that acts as a
gateway. A gateway acts as an entrance and exit to packets from and to other
networks.
Configure the primary IP address of the server used for DNS resolution.
Configure the secondary IP address of the server used for DNS resolution.
Installation wizard step 4 – Security parameters
Open: All Subscriber Module devices requesting network entry are allowed
registration.