CHAPTER 4: USING THE DEVICE
MANAGEMENT INTERFACE
USING THE INSTALLATION WIZARD
SUBSCRIBER MODULE
PAGE 4-13
The Preferred Access Points WPA2 Pre-shared Key must be configured on the
Subscriber Module device to match the pre-shared key configured on the Access
Point for registration with WPA2 security.
Configure the channel size used by the radio for RF transmission.
Radio Frequency
Scan List
Configure the frequency carrier for RF transmission. This list is dynamically
adjusted to the regional restrictions based on the setting of the Country
parameter. Ensure that a thorough spectrum analysis has been completed prior to
configuring this parameter.
Installation wizard step 3 – Network parameters
NAT: The SM acts as a router and packets are forwarded or filtered based on their
IP header (source or destination).
Bridge: The SM acts as a switch and packets are forwarded or filtered based on
their MAC destination address.
Router: The SM acts as a router and packets are forwarded or filtered based on
their IP header (source or destination) using specific static routes and IP aliases
configured by the operator.
To Next Page
Loading...
Need help?
General
