CHAPTER 4: USING THE DEVICE
MANAGEMENT INTERFACE
PREPARING FOR CONFIGURATION
PAGE 4-2
Preparing for configuration
This section describes the checks to be performed before proceeding with unit configuration.
Safety precautions
All national and local safety standards must be followed while configuring the units.
Warning Ensure that personnel are not exposed to unsafe levels of RF energy. The
units start to radiate as soon as they are powered up. Respect the safety standards
defined in Compliance with safety standards on page 6-70, in particular the minimum
separation distances.
Observe the following guidelines:
Never work in front of the antenna when the device is powered. Always power down the power supply
before connecting or disconnecting the Ethernet cable from the module.
Regulatory compliance
All applicable radio regulations must be followed while configuring the units and aligning the antennas.
For more information, Compliance with safety standards on page 6-71.
To Next Page
Loading...
Need help?
General
