ProtoCessor 1991 Tarob Court Milpitas, California 95035 USA Web: www.protocessor.com
Tel: (408) 964-4444 Fax: (408) 964-4425 email: support@protocessor.com
Invalid igniter on during setting
Invalid ignite failure delay setting
Invalid ignite failure response setting
Invalid ignite failure retries setting
Invalid ignition source setting
Invalid interlock open response setting
Invalid Interlock start check setting
Invalid LCI enable setting
Invalid lightoff rate setting
Invalid lightoff rate proving setting
Invalid Main Flame Establishing Period setting
Invalid MFEP flame failure response setting
Invalid NTC sensor type setting
Invalid Outlet high limit response setting
Invalid Pilot Flame Establishing Period setting
Invalid PII enable setting
Invalid pilot test hold setting
Invalid pilot type setting
Invalid postpurge time setting
Invalid power up with lockout setting
Invalid preignition time setting
Invalid prepurge rate setting
Invalid prepurge time setting
Invalid purge rate proving setting
Invalid run flame failure response setting
Invalid run stabilization time setting
Invalid stack limit enable setting
Invalid stack limit enable setting
Invalid DHW demand source setting
Invalid flame threshold setting
Invalid outlet high limit setpoint setting
Invalid Stack limit setpoint setting
Invalid modulation output setting
Invalid CH demand source setting
Invalid Delta T limit delay setting
Invalid outlet high limit enable setting
Invalid outlet connector type setting
Invalid inlet connector type setting
Invalid DHW connector type setting
Invalid Stack connector type setting
Invalid S2 (J8-6) connector type setting
Invalid S5 (J8-11) connector type setting
Internal fault: Safety relay test invalid state
4-20mA cannot be used for both modulation and setpoint control
Invalid fan speed error message
To Next Page
Loading...
Need help?
General