Camus Hydronics ProtoNode FPC-N34 User Manual

Page 72 of 87
ProtoCessor 1991 Tarob Court Milpitas, California 95035 USA Web: www.protocessor.com
Tel: (408) 964-4444 Fax: (408) 964-4425 email: support@protocessor.com
Alert Codes (Sola)
Code
Description
0
None (No alert)
1
Alert PCB was restored from factory defaults
2
Safety configuration parameters were restored from factory defaults
3
Configuration parameters were restored from factory defaults
4
Invalid Factory Invisibility PCB was detected
5
Invalid Factory Range PCB was detected
6
Invalid range PCB record has been dropped
7
EEPROM lockout history was initialized
8
Switched application annunciation data blocks
9
Switched application configuration data blocks
10
Configuration was restored from factory defaults
11
Backup configuration settings was restored from active configuration
12
Annunciation configuration was restored from factory defaults
13
Annunciation configuration was restored from backup
14
Safety group verification table was restored from factory defaults
15
Safety group verification table was updated
16
Invalid Parameter PCB was detected
17
Invalid Range PCB was detected
18
Alarm silence time exceeded maximum
19
Invalid safety group verification table was detected
20
Backdoor password could not be determined
21
Invalid safety group verification table was not accepted
22
CRC errors were found in application configuration data blocks
23
Backup Alert PCB was restored from active one
24
RESERVED
25
Lead Lag operation switch was turned OFF
26
Lead Lag operation switch was turned ON
27
Safety processor was reset
28
Application processor was reset
29
Burner switch was turned OFF
30
Burner switch was turned ON
31
Program Module (PM) was inserted into socket
32
Program Module (PM) was removed from socket
33
Alert PCB was configured
34
Parameter PCB was configured
35
Range PCB was configured
36
Program Module (PM) incompatible with product was inserted into socket
37
Program Module application parameter revision differs from application
processor
38
Program Module safety parameter revision differs from safety processor
39
PCB incompatible with product contained in Program Module
40
Parameter PCB in Program Module is too large for product
41
Range PCB in Program Module was too large for product
42
Alert PCB in Program Module was too large for product
43
IAS start check was forced on due to IAS enabled
44
Low voltage was detected in safety processor
45
High line frequency occurred
46
Low line frequency occurred
47
Invalid subsystem reset request occurred
48
Write large enumerated Modbus register value was not allowed
49
Maximum cycle count was reached
50
Maximum hours count was reached

Camus Hydronics ProtoNode FPC-N34 Specifications

General

Brand	Camus Hydronics
Model	ProtoNode FPC-N34
Category	Controller
Language	English