Canon DC 210 - Displaying the Photos

• ooo Playback
(approx. 1 second) at the pointwhere the
playback switches from Layer 1to Layer 2.
• You can display the date and time ofthe
recording andother camcorder data registered
when the recording was made (El3 51).
TO ADJUSTTHEVOLUME
The camcorder plays the sound with the
built-in speaker. The sound will be muted
when you close the LCD panel or connect
the stereo video cable to the AV terminal.
During the playback of a scene:
1 If the joystick guide does not appear
on screen, press (_)) to display it.
2 Push thejoystick(AY)toward I|,))or
I_ to adjust the volume.
• To turn off the volume completely,
keep pressing (T) until the volume
icon changes to _.
• You can press (_)) again to hide the
joystick guide during playback.
SPECIAL PLAYBACKMODES
• Fast Playback
During normal playback, press [_ or
[_ on the camcorder. Repeatedly press
the button to increase the playback
speed.
Fast playback: 5x ._ 15x _ 25x
the normal speed.
• Slow Playback
During playback pause, press [_ or
on the camcorder. Repeatedly press the
button to increase the playback speed.
Stow playback: 1/16 _ 1/8 ._ 1/4
the normal speed.
• SkippingScenes
During playback, push the joystick (_) to
skip to the next scene. Push the joystick
(4) to skip to the beginning of the current
scene. Push the joystick (4) twice to skip
to the previous scene.
Note that you do not have to display the
joystick guide above to skip the scene.
• There is no sound during special playback
modes.
• During some special playback modes, you
may notice some video problems (blocky video
artifacts, banding, etc.) in the playback picture.
• Slow playback is not available with discs
initialized in VIDEO mode.
• Depending on the recording, you might
occasionally notice a brief stop of the picture or
sound at the point where the scene changes.
Displaying the Photos
1 Move the power switch to ON, then
slide it down toward MODE and
release it to set the camcorder in
PLAY mode.
The green PLAY indicator will turn on.
2 Move the =m/_ switch to the 0
(Still images) position.
3 Use the joystick (4_) to move
between images.
II