Canon DC 210 - Recording Problems and Solutions

®oooTrouble?
Problem Solution
The disc cannot be ejected. Turn off the camcorder, disconnect the compact power adapter
and remove the battery pack. Restore the power supply and try
again.
The camcorder has exceeded its operational temperature. Turn
oft the camcorder and let it cool down before resuming use.
The disc cannot be recognized. The disc is dirty. Clean the disc with a soft lens-cleaning cloth. If
the problem persists replace the disc.
The disc is not correctly loaded. Check the disc.
Verify that the camcorder supports the type of DVD disc you
inserted.
The camcorder vibrates. Depending on the condition of the disc, the camcorder might
vibrate occasionally. This is not a malfunction.
• The disc's rotation can be The disc is activated from time to time. This is not a malfunction.
faintly heard.
• Occasionally the operation
sound can be heard.
After using the camcorder for a This is not a malfunction. Turn the camcorder off and let it cool
long time, "_" lights up in red. for a while before resuming operation.
73
22
5
Recording
Problem Solution
Image will not appear on the
screen.
"SET THE TIME ZONE, DATE
AND TIME" appears on the
screen.
Pressing the start/stop button
will not start recording.
Set the camcorder to _).
Open the lens cover.
Set the time zone, date and time.
Recharge the built-in lithium battery and set the time zone, date
and time.
Set the camcorder to
Load a recommended disc.
The disc is full (" _b END" flashes on the screen). Delete some
recordings (DVD-RW in VR mode) to free some space or
replace the disc.
The camcorder has exceeded its operational temperature. Turn
off the camcorder and let it cool down before resuming use.
Remove the disc protection.
Unfinalize the disc (DVD-RW in VIDEO mode).
The scene or still image is being recorded on the disc. This is
not a malfunction.
28
26
73
28
6
22
55
57
63
28
3O
Even after stopping recording,
the disc access indicator does
not go off.
The point where the start/stop There is a slight interval between pressing the start/stop button
button was pressed does not and the actual start of the recording on the disc. This is not a
match the beginning/end of the malfunction.
recording.
&
O
D
5-