Canon imageCLASS MF4370dn - Checking the Dial Line before Sending

Fax
5-28
Checking the Dial Line before Sending
Checking the Dial Line before Sending
Checking the Dial Line before Sending
The following redirection problem may happen with certain kinds of fax machines on the
market made by companies other than Canon. The DIALING LINE CHCK mode prevents this
rare occurrence from happening.
If you are sending a fax document from your machine at the same time another fax machine
(made by a company other than Canon) is trying to send you a fax, your fax document may
end up being redirected to that fax machine, instead of the original destination you had
intended.
Setting <DIALING LINE CHCK> to <ON> enables you to avoid such sending problems.
The default setting is <OFF>.
The DIALING LINE CHCK mode is enabled only after you disconnect the power cord, then connect the cord again.
1
Press [Menu].
2
Press [ ] or [ ] to select <FAX
SETTINGS>, then press [OK].
5 FAX SETTINGS
MENU
3
Press [ ] or [ ] to select <TX
SETTINGS>, then press [OK].
3 TX SETTINGS
FAX SETTINGS
4
Press [ ] or [ ] to select <DIALING
LINE CHCK>, then press [OK].
2 DIALING LINE CHCK
TX SETTINGS
5
Press [ ] or [ ] to select <ON>, then
press [OK].
ON
DIALING LINE CHCK
6
Press [Stop/Reset] to return to the
standby mode.