Setting Item Description, Instructions
Adjust
Printer
Feed
Priority
Adjust
Length
Change
Settings
B:Standard/Draft For paper that tends to stretch, increase the feed amount
by choosing a higher adjustment value. For paper that
tends to shrink, decrease the feed amount by choosing a
lower adjustment value. (See "Adjusting Line
Length.") ➔P.533
Mainte-
nance
Head Cleaning Clean the Printhead. (See "Cleaning the Print-
head.") ➔P.547
Choose Head Cleaning A if printing is faint, oddly col-
ored, or contains foreign substances.
Choose Head Cleaning B if no ink is printed at all, or if
printing is not improved by Head Cleaning A.
Nozzle Check Print a test pattern to check the nozzles.
Replace P.head Execute when replacing the Printhead. Follow the instruc-
tions displayed to complete the required procedure. (See
"Replacing the Printhead.") ➔P.548
Not displayed during a warning message that the remain-
ing Maintenance Cartridge capacity is low.
Repl. maint cart Execute when replacing the Maintenance Cartridge. Fol-
low the instructions displayed to complete the required
procedure. (See "Replacing the Maintenance Car-
tridge.") ➔P.554
Head Info Indicates information about the printhead.
GL2
Settings
Quality
Manag-
er
Color
Mode
Monochrome Print in monochrome.
Color (CAD) 1 Print in standard colors.
Color (CAD) 2 Print with approximate colors emulating Canon iPF750,
iPF755, iPF650, iPF655, iPF760, iPF765.(*2)
Color (CAD) 3 Print with approximate colors emulating Canon iPF500,
iPF600, iPF700, iPF510, iPF610, iPF710, iPF605, iPF720,
iPF810, iPF820, iPF815, iPF825.(*2)
Color (CAD) 4 Print emulating the HP Designjet 500/800, in colors re-
sembling colors produced by these printers.(*2)
Color (CAD) 5 Print emulating the HP Designjet T1100, in colors resem-
bling colors produced by this printer.(*2)
Print Quality Choose the print quality.
Input Resolution Choose the printer input resolution, 600dpi or 300dpi.
Print (Economy) When On is selected, print using less ink.
However, the quality is lower than regular printing.
Select On to conserve ink such as the layout confirmation.
Note that although Print (Economy) is only available
when Fast is selected in Print Quality, it might not be
available depending on the paper type.
Paper
Manag-
er
Paper Source Choose the source of paper for HP-GL/2 printing.
Margin Specify the margin around paper. The margin for the trail-
ing edge of sheets is 23 mm (0.9 in).
However, if you have specified the leading margin in Pa-
per Details, the larger of the setting values has priority.
Oversize Set the position of the margin relative to the image range.
Choose Off to set the margin inside the image range.
The image may be missing depending on the layout.
Choose On to set the margin outside the image range.
Although the image will not be missing, you should print
on paper larger than the size of the image range plus the
margins.
Conserve Paper Conserves paper when printing.
Menu Settings
iPF685
User's Guide
Control Panel Printer Menu
422
To Next Page
Loading...
Need help?
General