0JFC-00S
Loading Envelopes
Make sure to flatten any curls on envelopes before loading them. Also pay attention to the orientation of envelopes and which side is
face up.
Before Loading Envelopes
Loading Envelopes in the Multi-Purpose Tray and Manual Feed Slot
This section explains how to load envelopes in the orientation you want, as well as preparations that you need to complete before
loading envelopes. For a complete description of the procedure for loading envelopes in the multi-purpose tray or manual feed
slot, see the following.
Loading Paper in the Multi-Purpose Tray
Loading Paper in the Manual Feed Slot
Follow the procedure below to prepare the envelopes before loading.
When loading in the manual feed slot, only one envelope can be loaded at a time. Note that the preparations described in steps 1
to 3 below are necessary.
Close the flap of each envelope.
Press down to expel air from the envelopes and make sure that the folds on all four sides are sharp and that
the stack is flat.
Remove curls by flexing the stiff sections at the four corners.
Tap the stack on a flat surface to even the edges of the envelopes.
Before Loading Envelopes
1
2
3
4
㻟㻢㻌㻛㻌㻞㻠㻜
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
